Honeywell BENDIX/KING KAP 140

BENDIX/KING

KAP 140

Page 3--29

Revision 2, Dec/2002

CS:15574F02

3.4.2 INSTALLATION OFFSETS

Pressing ‘2’ followed by ‘ENTER’ when the Installation Menu screen is displayed will cause the

Installation Offsets screen to be displayed, as shown in Figure 3--17. Pressing the ‘ENTER’ key

at this point will return the user to the Installation Menu screen.

This screen lists sensor inputs to the FCC whose offsets can be compensated for by software in

order to optimize system performance. These adjustments are stored in the configuration module

and may be repeated without performing installation setup again.



System mode: Normal

SET INSTALLATION OFFSETS

------------------------

1 - Glideslope Deviation

2 - Localizer Deviation

3 - VOR Deviation

4 - GPS Deviation

5 - Heading Datum

6 - Course Datum

Press key for desired option (<CR> to exit)

FIGURE 3--17 INSTALLATION OFFSETS SCREEN

When a sensor input is selected, as shown in Figure 3--18, the FCC prompts the user to press the

‘ENTER’ key when the sensor NULL position is reached. The installer should make sure the

sensor input is nulled before proceeding. When the ‘ENTER’ key is pressed, the analog value is

read by the FCC and stored in the configuration module and used to compensate the sensor when

the autopilot is engaged.

