Honeywell CK75 - How to Replace the I;O Cover on Non-Incendive Models

75 Series Mobile Computer User Guide 7
How to Replace the I/O Cover on Non-Incendive Models
An I/O cover is supplied with non-incendive versions of the CN75 and CN75e
computers. After charging the battery, always immediately install the I/O cover.
1. Loosen the screws securing the I/O cover to the computer.
2. Press the release buttons on the sides of the cover, and remove the cover.
3. Detach the security tether.
4. Attach the security tether on the replacement I/O cover to the computer.
Warning: Warning: The I/O cover must be attached when using the CN75/CN75e
NI in a dangerous environment.
Avertissement : Avertissement : Le couvercle entrée-sortie doit être fi xé lorsque
le CN75/CN75e NI est utilisé dans un environnement
incendiaire.