Honeywell CK75 - How to Read Bar Codes with the Camera

64 75 Series Mobile Computer User Guide
How to Read Bar Codes with the Camera
You can use the camera to read bar codes. When you read bar codes with the
camera, the computer treats the camera as it would any input device, such as a
Bluetooth scanner, and bar code data is sent to an application as if it came from a
scanner or imager.
Note: To read bar codes using the camera, you must use Enterprise Settings to configure
bar code symbology decode settings.
There are two ways to enable reading bar codes with the camera:
• You can use the Profile Settings application to enable bar code reading. The
computer uses the current symbology decode settings to read bar code data.
• You can configure individual parameters in Enterprise Settings (Data Collection
> Camera > Scanner Settings) to enable bar code reading.
Note: Parameters set in Data Collection > Internal Scanner > Scanner Settings are applied
to the internal imager, not the camera.
Video resolution • 720 x 1280 (720p) (Default)
• 768 x 1024 (XGA)
• 480 x 800 (WVGA)
• 480 x 640 (VGA)
• 288 x 352 (CIF)
• 240 x 320 (QVGA)
Video encoder • H263
• H264 (default)
• MPEG4
•WMV
Video file format • *.3gp
•*mp4
Hold record When Timer mode is enabled, this value is the
delay in seconds before recording begins.
Enable video
stabilization
Check the box to enable video stabilization.
Enable video noise
filtering
Check the box to enable video noise filtering.
Enable video noise
filtering
Check the box to enable video noise filtering.
Frame rate • 15 fps
• 30 fps (default)
• Custom: Adjust the frame rate with the
slider.
Setting Description Choices