• Support software (Off-Line Configurator, On-Line Graphic Program Editor) -
operates via RS485 communications link.
The Digital Controller Programmer has four operating modes:
Base Mode: Day-to-day PID control operations with no program running. In
this mode, a program may be selected to run.
Program Run Mode: A selected program is running, held or waiting for a
pre-defined delay before starting. In this mode, the operator can view
status and program information.
Program Define Mode
1
: Used to view/create/edit programs. This mode is
entered either from Base Mode (selected program may be edited/created)
or from Program Run Mode (currently-running program may be edited).
Controller Define Mode
2
: Used to define the Controller characteristics.
1 -2
1 Entry via Lock Code; also optional Program Lock prevents changing of program definitions
while a program is running.
2 Entry via a Lock Code.
To Next Page
Loading...
