9
Installing a Memory Card
1. Press the Power key to put
the terminal in Suspend Mode.
2. Release the hand strap near the
base of the terminal.
3. Remove the battery door and the
battery.
4. Remove the protective cover over
the memory socket.
5. Unlock the access door to the
memory socket by sliding the
door away from the serial number
label located in the battery well.
6. Lift the door up to expose the
socket.
7. Insert the microSD or microSDHC
card into the socket.
Note: Make sure the interface on the
memory card is connected to
the interface in the socket; align
the notch on the card with the
notch of the socket.
8. Close and lock the access door
by sliding the door toward the
serial number label.
9. Replace the protective cover over
the memory socket.
10. Install the battery and the battery
door.
Step 4
Step 5
Step 6
Step 4
Step 4
Step 9
Step 8
Step 7
97_QS.book Page 9 Thursday, September 9, 2010 9:57 AM
To Next Page
Loading...
