15
Soft Reset (Warm Boot)
A soft reset re-boots the device without losing RAM data.
1. Press and hold the RED + TAB keys for
approximately 5 seconds.
2. The decode and scan LEDs flash for approximately
three seconds as the terminal resets.
3. When the reset is complete, the Today screen
displays.
Hard Reset (Cold Boot)
A hard reset resets the operating system, restores the
terminal back to factory defaults, and resets the terminal
after a bootloader, keyboard, and kernel upgrade.
A hard reset erases all of the data stored in RAM memory
and all RAM installed applications!
1. Press and hold the RED + ENT keys for
approximately 5 seconds.
2. The decode and scan LEDs light for approximately
3 seconds.
3. The terminal re-initializes.
97_QS.book Page 15 Thursday, September 9, 2010 9:57 AM
To Next Page
Loading...
