4
Install the Main Battery Pack
The 9700 is shipped with the battery packaged separate
from the unit. Follow the steps below to install the main
battery.
1. Release the hand strap near the base of the terminal.
2. Remove the battery door by releasing the door latch
and pulling up with a hinging motion.
3. Insert the battery into the battery well.
4. Replace the battery door. Apply pressure to engage
the door latch.
Note: The battery door must be installed prior to
powering the unit.
5. Reattach the hand strap.
6. Connect the terminal to one of the 9700 series
charging peripherals to charge the main battery pack.
We recommend use of Honeywell Li-Ion battery packs.
Use of any non-Honeywell battery may result in damage
not covered by the warranty.
97_QS.book Page 4 Thursday, September 9, 2010 9:57 AM
To Next Page
Loading...
