12
Using the Scan Image Engine
1. Tap Start > Demos > Scan Demo
2. Point the Dolphin’s terminal at the bar code.
3. Project the aiming beam or pattern by pressing and
holding the SCAN key or one of the terminal’s
side buttons.
4. The red LED lights.
5. Center the aiming beam over the bar code; see
Aiming Options on page 13.
6. When the bar code is successfully decoded, the LED
changes to green and the terminal beeps.
7. The bar code information is entered into the
application in use.
97_QS.book Page 12 Thursday, September 9, 2010 9:57 AM
To Next Page
Loading...
