Honeywell Domonial - Keypad Error Handling; Incorrect Code or Invalid Tag; Faults on Arming and Disarming

13
After five attempts to enter a 4- or 6-digit code , the keypad locks out all users for five
minutes.
If an invalid TAG is touched to the keypad, the screen displays:
After five attempts to use the TAG, the keypad locks out all users for five minutes.
INCORRECT CODE OR INVALID TAG
IDENTIFICATION
ERROR
When faults are present or in the memory while you are trying to arm the system, they
are indicated by an icon and a message on the keypad screen:

Press to acknowledge the messages and continue the arming process.
 Memorised faults are cleared from the memory and faults currently occurring are
bypassed.

Press to cancel the arming process.
FAULTS ON ARMING
ALARM
-----------------------
TAMPERING
ALL SETS
OVERRIDE?
-----------------------
<=
OK
When faults are present or in the memory after you have disarmed the system, they are
indicated by an icon and a message on the keypad screen.

Press to clear faults in the memory and reset the system. Press again to
review the list of faults currently occurring .

Press to exit the screen. See also System Lock, below.
FAULTS ON DISARMING
END OF FAULTS
MEMO
-----------------------
INTRUDER
TOTAL SET
RESET?
-----------------------
<=
OK