AlcoQuant 6020 plus
14 Doc no.: 059-07-1001779_A6020plus_GB-5.2.1 / 12.2021
3.3.7 Printer settings (optional)
This menu items determines Settings regarding the printer output.
Within the menu >Settings<, select the menu item >Printer Setup<.
This item is only available for devices with wireless option.
Confirm > Printer Setup< with >OK<.
Then select the desired printing option: >
cable is installed between printer and device.
The subsequent key >Print< will initiate a test printout.
Having selected the option >Wireless<, an appropriate wireless
printer can be used. Prior to the initial wireless operation, the printer
and the AlcoQuant 6020 plus need to be paired with each other by
using the Connection ID of the printer. T
printer Connection ID have to be set with the key >Edit<. Finally
confirm the Connection ID with >OK<. A printer test can then be
performed with >Print<.
The six digit Connection ID is stated on the label of the printer but
can also be found on the self test printout (See the printer’s
3.3.8 Factory settings
This menu item resets the device back to its factory settings.
Select >Factory settings< from the >Settings< menu.
Confirm the >Factory settings< selection with >OK<.
Press >Yes< to reset the device.
All personalised settings such as choice of measurement value, info
texts, volume, etc., will be deleted and replaced with the factory
defaults.
The device switches itself off once the reset is complete.
The data in the memory module is not affected by the reset.
To Next Page
Loading...
Need help?
General
