Honeywell ERX - Parameter Item List (Modem Control & P3 Alarms); Modem AT Enable Selection; Call-out Time Control Settings; P3 HighHigh and LowLow Alarm Configuration

65

Item Item Name & Description
789 Modem AT Enable
Selection to that determines the type of call-in initiated by the recorder.
Code Value
0 Call-in via alarm pulse
Default:1 Call-in via AT commands
790 Parameter used to set the amount of time to leave the system powered up after a call-in
(allowing time for the host to call-back). Time is specified in minutes.
Defaul
t: 15 minutes
791 Call-out Start Time
Parameter used to set the time of day to start the call-out cycle when using modem power
control.
Default: 00 00 00
792 Call-out Repeat Interval
Parameter used to set the amount of the time to wait from the beginning of the current
interval until repeating the call-out window set by the call-out keep alive time, specified
in minutes.
Default: 0 min
utes
793 Call-out Keep Alive Time
Parameter used to set the time of day to start the call-out cycle when using modem power
control.
Default: 0 minutes
807 P3 High/High Alarm Limit
The high/high alarm feature adds an additional alarm notice, that is, in addition to the
normal high alarm limit set by item 455 and even higher alarm limit may be set, which
creates a two-step alarm noti
fication.
Default: 333.00
808 P3 Low/Low Alarm Limit
The low/low alarm feature adds an additional alarm notice, that is, in addition to the
normal low alarm limit set by item 456 and even lower alarm limit may be set, which
creates a two-step alarm notification.
Default: -1.00
809 P3 High/High Alarm
Code Value
Default: 00000000 No alarm
11111111 Alarm
810 P3 Low/Low Alar
m
Code Value
Default: 00000000 No alarm
11111111 Alarm