Every effort has been made to ensure the accuracy of this document; however, Honeywell Analytics can assume no
responsibility for any errors or omissions in this document or their consequences.
Honeywell Analytics would greatly appreciate being informed of any errors or omissions that may be found in the content of this
document.
For information not covered in this document, or if there is a requirement to send comments/corrections about this document,
please contact Honeywell Analytics using the contact details given on the back page.
Honeywell Analytics reserve the right to change or revise the information supplied in this document without notice and without
obligation to notify any person or organization of such revision or change. If information is required that does not appear in this
document, contact the local distributor/agent or Honeywell Analytics
2.3 FSL100 Safety Features
The FSL100 has the following safety features:
Hazardous area certified: ATEX Zone 2/22, FM Class 1, 2, 3 Div. 2
Performance certified: EN54-10 and FM 3260
Robust Glass Reinforced Polyester (GRP) housing, which is available in standard red housing or white housing options and
is:
o Light weight but impact resistant
o Weather sealed and incorporating pressure compensating breather
o Non-Incendive (flameproof), non-corrosive and UV resistant
Automatic Sensor self-test continuously monitors the sensors, electronics and firmware for proper operation
Manual Self test initiated by contact closure
Relay and mA sink outputs and selectable latching / non-latching alarm relay outputs
Local status LEDs
Optional (safe area or hazardous area) Function Test Lamps to enable simple coverage and operational checks of the
Honeywell FSL100 series Flame Detectors (with long range test source detection)
To Next Page
Loading...
