Honeywell Galaxy 60

Galaxy Programming Manual
151
Option 64 – Assemble Zone (Galaxy 18, 60, 128, 500, 504 & 512)
The Assemble Zones option allows 2 zone functions to be customised to the user’s requirements; these are
the Custom-A and Custom-B zones. Once a custom zone function has been assembled, it is assigned to
zones using option 52 = PROGRAM ZONES.
Programming a Custom Zone
The flexibility of this menu option allows for an extensive range of possibilities. It is therefore important that
the engineer is fully aware of the system and has a clear picture of what is required of the new zone function.
The procedure for assembling a custom zone has 4 stages:
1. Outputs
2. Status
3. Setting
4. Log
Table 29. Programming a custom Zone
64 - Assemble Zones
stuptuO=1:epyTtuptuOdelbasiD
teS
tesnU
tesnU/teS
epyttuptuotceles–B/A
tesnU,teS,delbasiDneewtebelggot–#
tesnU/teS&
gnimmargorpevas–cse
sutatS=2tesnU=1delbasiD
mralA
mralAdnadelbasiDneewtebelggot–#
gnimmargorpevas–cse
tixE/yrtnE=2delbasiD
mralA
teStraP=3delbasiD
mralA
teSlluF=4delbasiD
mralA
gnitteS=3teSnigeB=1delbasiD
delbanE
dnadelbasiDneewtebelggot–#
delbanE
gnimmargorpevas–cse
yrtnEnigeB=2delbasiD
delbanE
steS=3
metsyS
delbasiD
delbanE
goL=4delbasiD
tixEyrtnE
sruoH42
smralA
,tixE/yrtnE,delbasiDneewtebelggot–#
evas–csesmralA&sruoH42
gnimmargorp