Honeywell Galaxy 60

Galaxy Programming Manual
81
Option 53 – Program Outputs
This option is used by the engineer to modify the programming of the outputs on the system. The option also
allows the attributes of the outputs to be changed. The programmable options are:
Table 16. Output Attributes
Selecting Outputs
On entering the option, the first output on the system is displayed; the output address, function and mode are
displayed on the top line, the polarity and assigned groups are displayed on the bottom line.
From the display of the first output, any output on the system can be displayed by pressing the A or B keys or
by entering the address of a specific output.
NOTE: For direct output address selection the Galaxy 8, 18 and 60 only require the last 2 digits of the
zone address to be entered; the Galaxy 128, 500, 504 and 512 require a 4 digit address to be
entered.
The output is selected for programming by pressing the ent key; the first output programming attribute 1=Op
Function is displayed.
53 - Program Outputs
setubirttAnoitpircseD
1noitcnuFtuptuOepyttuptuongissA
2edoMtuptuOteserotedocdilavseriuqer-hctaL=1
senozfosutatsnoitavitcaswollof-xelfeR=2
doirepdemmargorprofsetavitca-)sces0003-100(esluP=3
3ytiraloPtuptuOnoitavitcaniV0otgniogV21-SOP=0
noitavitcaniV21otgniogV0-GEN=1
4spuorGtuptuOtuptuoehtotspuorgngissA
delbanesinoitpopuorGehtfiraeppaylnospuorG:etoN
.)spuorG.SNOITPO=1.36noitpootrefer(