Honeywell Galaxy 60

Galaxy Programming Manual
32
1 = Modify PIN
The PIN identifies each user to the Galaxy panel and permits the user to operate the system. The Modify
PIN option allows a PIN to be assigned to the user or an existing PIN to be modified. The PIN must be a
four, five or six digit number that is unique to the system. If a duplicate PIN is assigned, the message
INVALID SELECTION is displayed; the PIN is not assigned to the user. As each digits is entered it ap-
pears on the lower line of the display. Pressing the ✴ key erases the last digit displayed; continued pressing of
the ✴ key will erase all of the digits. When the correct PIN has been assigned press the ent key to accept the
programming and, if a MAX No. is assigned the display will prompt: delete max no. A = YES, B = NO
and return to the previous menu level. When a PIN has been assigned to a user number, a solid box (■) is
displayed on the top line of the user number details screen.
Deleting a PIN
Existing PIN entries can be completely erased by using the ✴ key instead of a digit entry. When there is no
PIN assigned to a user number a hollow square () is displayed on the top line of the user number details
screen.
Assigning Dual Codes
To program a user code as a Dual Code press the # key while the Modify PIN option is selected. The #
displays at the start of the assigned user PIN (#1314). When a PIN has been assigned as a dual code 2 solid
boxes (■ ■) are displayed on the top line of the user number details screen.
NOTE: The Master manager code can not be assigned as dual.
Dual Codes Operation (Galaxy 60, 128, 500, 504 & 512)
Entry of a single dual code can not gain access to the menu, set or unset the system. The message NO AC-
CESS – ADDITIONAL CODE is displayed. A second dual code must be entered within 60 seconds of the
first dual code to access the menu, set or unset the system. Dual codes can be different levels, the highest level
entered is granted access to the system — whether it is entered first or second.
A single entry of a dual code - without a second dual code entry within 60 seconds - is recorded in the event
log as an Illegal Code; all outputs programmed as Illegal Code are activated. 2 = Modify Level
Dual Focus (V4 and above)
If a MAX number for the same user has a # assigned the dual function only works between the PIN and the
MAX card of the same user.
2=Modify Level
Each user is assigned an access level which determines the menu options available to the user. The program-
mable levels are from 0 - 6; 7 is assigned to the engineer level — this is fixed and cannot be assigned to user
codes; 8 is assigned to the remote code. This is fixed and cannot be assigned to the engineer or user codes,
keypad (E) only.
On selecting this option, enter the level to be assigned to the user and press the ent key to accept the pro-
gramming and return to the previous menu level.
42 - Codes (cont’d)