Galaxy Programming Manual
64
51 - Parameters (cont’d)
58 = Power Alarm
For NF-a2p approval. Activates Bells, Strobe and Horn when system is set if there is an AC fail.
59 = Part Zone
For NF-a2p approval. When enabled, the part setting has a unique setting tone. Setting tone is on 2 secs, off
0.1 sec.
60 = Supervision
This parameter has two sub options:
1 = Silent Alarm. If enabled, it stops Supervision alarms from activating sounders when set.
2 = Debounce. This extends the normal 2 hour delay for supervision by a further 24 hours.
To Next Page
Loading...
