Honeywell Granit 1980i - Page 289

Xenon/Granit User Guide 269
RS232 Handshaking *RTS/CTS Off 232CTS0 37
Flow Control, No Timeout 232CTS1 37
Two-Direction Flow Control 232CTS2 37
Flow Control with Timeout 232CTS3 37
RS232 Timeout 232DEL#### 37
*XON/XOFF Off 232XON0 38
XON/XOFF On 232XON1 38
*ACK/NAK Off 232ACK0 38
ACK/NAK On 232ACK1 38
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 39
Packet Mode On 232PKT2 39
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 39
Bioptic ACK/NAK On 232NAK1 39
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout
*5100
232DLK##### 39
Cordless System Operation: Xenon 1902g/1912 and Granit 1911i/1981i
This section applies only to cordless systems. It does not apply to corded scanners or Xenon 1902g-BF
scanners.
Replace a Linked Scanner Override locked Scanner (Single
Scanner)
BT_RPL1 43
Temporary Streaming Presentation
Mode
*Temporary Streaming
Presentation Mode On
BEPPGE2 46
*10 Second Timeout TRGTPM10000 46
60 Second Timeout TRGTPM60000 46
Base Power Communication
Indicator
*On :*:BASRED1 50
Off :*:BASRED0 50
Reset Scanner Reset Scanner RESET_ 50
Scan While in Base Cradle Scan in Cradle Off BT_SIC0 50
*Scan in Cradle On (CCB01-
010BT default)
BT_SIC1 50
Shut Down Scanner in Cradle BT_SIC2 50
Base Charge Modes Base Charge Off BASCHG0 51
*External or Interface Cable Power BASCHG1 51
External Power Only BASCHG2 51
Page Mode *On BEPPGE1 51
Off BEPPGE0 51
Page Pitch Range 400 - 9000 Hz (*1000) BEPPFQ#### 51
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page