Xenon/Granit User Guide 61
Flash Storage: The scanner writes any untransmitted data to flash memory prior to
powering down. The data will still be there when the scanner powers back up. How-
ever, the scanner will power down, even with untransmitted data, if it reaches a
power down timeout or if the battery power is very low.
RAM Storage: The scanner will not power down while it contains data that has not
been transmitted to the base or Access Point, even if it reaches a power down time-
out. However, if the scanner runs out of battery power, it will power down and the
data will be lost.
Default = Flash Storage.
Batch Mode Quantity
When in Batch Mode, you may wish to transmit the number of multiple bar codes
scanned, rather than a single bar code multiple times. For example, if you scan
three bar codes called XYZ with Batch Mode Quantity Off, when you transmit your
data it will appear as XYZ three times. Using Batch Mode Quantity On and the
Quantity Codes (page 63), you could output your data as “XYZ, 00003” instead.
Note: If you wish to format your output, for example, place a CR or tab between the bar code
data and the quantity, refer to Data Format beginning on page 157.
Default = Batch Mode Quantity Off.
Enter Quantities
Quantity Codes (page 63) allow you to enter a quantity for the last item scanned,
up to 9999 (default = 1). Quantity digits are shifted from right to left, so if a 5th digit
is scanned, the 1st digit scanned is discarded and the 2nd, 3rd and 4th digits are
moved to the left to accommodate the new digit.
* Batch Mode Quantity Off
To Next Page
Loading...
