Honeywell Granit 1980i - Page 292

272 Xenon/Granit User Guide
Bluetooth HID Keyboard
Disconnect
PAPSPP 71
Bluetooth Serial Port - PCs/
Laptops
BT_TRM0;BT_DNG5 72
BT Connection - PDA/Mobility
Systems Device
BT_TRM0;BT_DNG1 72
Bluetooth PIN Code BT_PIN 72
Auto Reconnect Mode *Auto Reconnect On BT_ACM1 73
Auto Reconnect Off BT_ACM0 73
Maximum Link Attempts Maximum Link Attempts BT_MLA### 74
Relink Time-Out Relink Time-Out (*3) BT_RLT### 74
Host Command Acknowledgment Host ACK On HSTACK1 77
*Host ACK Off HSTACK0 77
Host ACK Timeout HSTATO## 77
Cordless System Operation: Xenon 1902g-BF
This section applies only to Xenon 1902g-BF systems. It does not apply to corded scanners or other cord-
less systems.
Replace a Linked Scanner Override locked Scanner (Single
Scanner)
BT_RPL1 80
Low Power Alert Range *Low Power Alert 10-30% LPIRAG0 85
Low Power Alert 10-50% LPIRAG1 85
Low Power Alert Flash Number Range 1-9 (*3) LPIFNO 85
Interval Between Flashes Range 1-9 seconds (*2) LPIFDL 85
Low Power Alert Repeat Range 1-5 (*1) LPI_NO 85
Interval Between Alerts Range 10-120 seconds (*10) LPI_DL 86
Low Power Alert Beep Low Power Alert Beep Off LPIBEP0 86
*Low Power Alert Beep On LPIBEP1 86
Temporary Streaming Presentation
Timeout
Range 0 - 300000 ms (*10000) TRGTPM###### 89
*10 Second Timeout TRGTPM10000 89
30 Second Timeout TRGTPM30000 89
1 minute Timeout TRGTPM60000 89
2 Minute Timeout TRGTPM120000 89
3 Minute Timeout TRGTPM180000 89
Base Power Communication
Indicator
*On :*:BASRED1 87
Off :*:BASRED0 87
Reset Scanner Reset Scanner RESET_ 87
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page