Honeywell Granit 1980i - Chapter 13 - Product Specifications; Xenon 1900;1900 h;1910 Corded Scanner Product Specifications

Xenon/Granit User Guide 275
Batch Mode Transmit Delay *Off BATDLY0 103
Short (ms) BATDLY250 103
Medium (ms) BATDLY500 103
Long (ms) BATDLY1000 103
Scanner Name Name 1-7 BT_NAM##### 105
Reset RESET_ 104
Scanner Name BT_NAM 105
Bluetooth Connection Bluetooth PIN Code BT_PIN 105
Auto Reconnect Mode *Auto Reconnect On BT_ACM1 105
Auto Reconnect Off BT_ACM0 105
Maximum Link Attempts Maximum Link Attempts (*4) BT_MLA### 106
Relink Time-Out Relink Time-Out (*2) BT_RLT### 107
Host Command Acknowledgment Host ACK On HSTACK1 109
*Host ACK Off HSTACK0 109
Host ACK Timeout HSTATO## 109
Input/Output Selections
Power Up Beeper Power Up Beeper Off - Scanner BEPPWR0 111
*Power Up Beeper On - Scanner BEPPWR1 111
Power Up Beeper Off - Cordless
Base
BASPWR0 111
Power Up Beeper On - Cordless
Base
BASPWR1 111
Beep on BEL Character Beep on BEL On BELBEP1 112
*Beep on BEL Off BELBEP0 112
Trigger Click On BEPTRG1 112
*Off BEPTRG0 112
Beeper - Good Read Off BEPBEP0 112
*On BEPBEP1 112
Beeper Volume - Good Read Off BEPLVL0 112
*Low (Default-Xenon HC) BEPLVL1 113
Medium BEPLVL2 113
*High BEPLVL3 113
Beeper Pitch - Good Read
(Frequency)
Low (1600) (min 400Hz) BEPFQ11600 113
*Medium - Xenon (2700 Hz) BEPFQ12700 113
*Medium - Granit (3200 Hz) BEPFQ13200 113
High (4200) (max 9000Hz) BEPFQ14200 113
Vibrate - Good Read Vibrate - Good Read Off TFBGRD0 113
*Vibrate - Good Read On TFBGRD1 113
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page