Honeywell HDZ302DIN - Page 72

www.honeywell.com/security
72 | equIP® Series 30x Zoom WDR PTZ Camera User Guide
To enable camera tampering detection:
1. Select the Enable Tamper Detect and/or the Enable Defocus Detect check box(es).
2. Next to Alarm Period, click Setup. The Alarm Period window opens.
3. Set the days and times when you want the alarm function to be active, and then click
Save.
4. To start recording video when a camera tampering event is detected, ensure that the
Record check box is selected.
5. In the Record Delay field, enter the number of seconds that the system will continue to
record video after a camera tampering event has ended. Enter a value between 10 and
300.
6. To generate an alarm output when a camera tampering event is detected, select the
Alarm Output check box and select the alarm output(s) to be activated .
7. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after a camera tampering event has ended. Enter a value
between 10 and 300.
8. To send an email notification when a camera tampering event is detected, select the
Send Email check box. Email settings must be configured in Setup > Network Setup >
SMTP (Email). See Configuring Email Settings on page 59.
9. To initiate a predefined preset, tour, or pattern when a camera tampering event is
detected, select the
PTZ check box and select the desired action from the Activation list.
10. To take a snapshot when a camera tampering event is detected, select the Snapshot
check box.
Note For the snapshot to be attached to the email notification, the Attachment check
box must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings on page 59.
11. Click Save to apply the settings.