Honeywell HEN643 4 Series User Manual

Performance Series Network Video Recorder User Guide
190
4. Use the mobile device’s camera to view the QR code on the P2P screen.
5. The HonView Touch app will automatically download the NVR information and establish a
connection.
Configuring Switch Settings
Note
This function is only available for
HEN081*4/HEN162*4/HEN163*4/HEN161*4/HEN322*4/HEN323*
4/HEN321*4/HEN642*4/HEN643*4/HEN041*3/HEN081*3/HEN16
1*3.
You can change the IP Address, Subnet Mask, and Default Gateway for setting the PoE switch
settings.
1. Click Switch under Network to open the Switch interface.
Figure 12-62 Switch Configuration Interface
2. Configure the following settings:
Table 12-19 Switch Configurations
Configuration Description
IP Address Enter a new IP address.
Subnet Mask Enter a new subnet mask.
Default Gateway Enter a new default gateway.
3. Click OK to save your settings.
Configuring Event Settings
Motion Detection Configurations
You can configure the system to generate a motion detection alarm when the minimum
amount of motion (as defined by you) is detected in the video.
1. Click Video Detection  Motion Detection under EVENT to open the Motion Detect
configuration interface.

Honeywell HEN643 4 Series Specifications

General

Brand	Honeywell
Model	HEN643 4 Series
Category	Network Hardware
Language	English