Web Client Operation
215
Configuring System Settings
General Settings
Click General under SETTING to open the General settings configuration interface. Update
the general settings as required and click OK to save the settings.
Figure 12-89 General Settings Interface
Table 12-27 General Settings Configurations
Configuration Description
Device Name Enter a device name.
Device No. Enter an NVR number.
Language
Select a GUI language from the drop-down list.
Note: You need to reboot the device/NVR to activate this change.
Auto Logout
Set the length of time the NVR waits before logging out an inactive
user. Specify a time between 0 and 60 minutes. The default setting is
10 min.
Navigation Bar
Select the check box to display the live view toolbar on the live view
screen. Clear the check box to hide the live view toolbar.
Authentication
Mode
Check to enable the authentication mode for using the keyboard. If the
authentication mode is not applicable to your keyboard, uncheck it.
Date and Time Settings
Click the Date & Time tab in the GENERAL configuration interface to open the Date & Time
configuration interface. Update the date and time settings as required and click OK to save
the settings.
To Next Page
Loading...