Honeywell Portable Electrical Generator Service Manual www.honeywellgenerators.com 5-1
5: PREPARING FOR SERVICE
5.1 REQUIRED TOOLS
A complete set of standard and metric shop tools are
required to service the generator. Also needed are:
• Hammer
• Torque wrench
• Volt-ohm meter
• Frequency meter
• Resistive load - such as a load bank, heaters, light
bulbs, etc.
• Alternator removal tool
• Wood block (for rotor support)
5.2 TRANSPORTING GENERATOR
When moving or transporting the generator:
• Press the engine control switch to the STOP position.
• Turn the fuel shut-off valve to the OFF position.
• Keep the generator level to prevent fuel spillage.
• Place pins in the handle and handle bracket before
moving the generator.
ANYONE using or servicing this generator must read, understand, and follow all safety and operation instructions provided in
this manual. Failure to closely follow these instructions can result in circumstances leading to death, serious injury, and prop-
erty damage.
Hot engine or exhaust system can cause serious
burns or fires. Cool generator completely before
transporting.
NOTICE
NEVER drop, strike, or place heavy objects on generator
when transporting.
To Next Page
Loading...
Need help?
General
