BCU 480 · Edition 03.16l 28
Function
Program status
DISPLAY
Fault message (flashing)
BCU 480
BCU 480..B1
30
EEPROM data change, NFS*
31
EEPROM data change, FS*
32
Undervoltage in power pack
33
Faulty parameterization
Bus module fault
51
Safety interlock failure
52
Permanent remote reset
53
Timing cycle too short
In Manual mode, two dots will blink on the display in program status 01–08.
= standard, = option.
* FS = input/output, safety circuit, NFS = input/output, control system.
To Next Page
Loading...
