– 65 –
SYSTEM FUNCTIONS
SYSTEM FUNCTIONSSYSTEM FUNCTIONS
SYSTEM FUNCTIONS
Testing the System (to be conducted weekly)
Test Modes
The Test icon provides access to the Walk Test and Reboot functions. The Walk Test mode allows each
protection point to be checked for proper operation. When the Walk Test mode is active, the control sounds a
single beep every 30 seconds as a reminder that the system is in the Test mode. The Reboot feature allows you
to reboot the system if required.
NOTE: An alarm message will not be sent to your alarm monitoring company during these tests.
Entering Test Mode
Disarm the system and close all protected windows, doors, etc. The “Ready” indicator should be lit.
Testing or Rebooting the System
Arm Away
Ready To Arm
Arm Stay
BackDelay
Settings
10:18 AM June 8, 2010
5200-100-033-V0
Tools
1. With the system in the disarmed state, select the “Tools” icon
from the second page of the Security Screen. The system
displays the Keypad screen.
Ready To Arm
Program the system
Enter Code :
Ca nc el
5200-100-035-V0
2 31
5
64
0
8
97
Cl ea r
2. Enter your 4-digit Master User Code. The system displays the
Master User programming screen.
WiFi ConfigDate Time
Ready To Arm
Events
Back
Reminders
KeypadUsers
5200-100-036-V0
Slide Show
Test
3. Select the “Test” icon. The system displays the Test screen.
To Next Page
Loading...
Need help?
General
