Honeywell Marathon - Wep

WEP
To connect using WEP, make sure the following profile options are used.
l Enter the SSID of the Access Point assigned to this profile
l Set EAP Type to None
l Set Encryption to WEP or Manual WEP (depending on SCU version)
l Set Auth Type to Open
Click the WEP keys/PSKs button.
Valid keys are 10 hexadecimal or 5 ASCIIcharacters (for 40-bit encryption)or 26 hexadecimal or 13 ASCII characters (for 128-
bit encryption). Enter the key(s) and click OK.
Once configured, click the Commit button. Ensure the correct Active Profile is selected on the Main tab and restart. The SCU
Main tab shows the device is associated after the radio connects to the network.
4-27