5EN
INSTALLATION (CONTINUED)
Through a Drilled Hole in the Wall or Window
If required, your Local Air Conditioner can be installed semi-permanently.
Note: When the unit is not in use, remove the Exhaust Hose from the Flange Fixture on the wall and
use the included Hole Cover to cover the hole on the wall.
Drill a hole through an outside wall or through a window pane. Respect the height and dimensions
of the hole given in Fig. 1 and Fig. 2.
Insert and secure the Flange Fixture + Hole Cover into the newly drilled hole.
Fix one end of the Exhaust Hose into the Flange Fixture + Hole Cover that was secured
on the wall.
Fix the other end of the Exhaust Hose onto the Exhaust Hose Connector and then onto the rear
Exhaust outlet of the unit (See Fig. 2).
1.
2.
3.
4.
MAX. 14" (36 cm)
MAX. 40" (102 cm)
20" (50 cm)
11.8" (30 cm)
5.9" (15 cm)
Fig.2Fig.1
In the
window
panel
In the wooden
kickboard
of a french
window
In the wall: we
recommend you to
insulate the section
of wall using suitable
insulation materials.
To Next Page
Loading...
Need help?
General
