8
USB: Low Speed USB (-38)
Full Speed USB (-40)
1. Turn off the host system.
2. Connect the 10-pin RJ45
male connector of the USB
cable into the jack on the
Eclipse. There will be a ’click’
when the connection is made.
3. Connect the other end of the
USB cable to the host USB port.
4. Turn on the host system.
Figure 9. USB
Installation Notes
As a default, the MS5145-38 leaves the factory with
USB Keyboard Emulation Mode enabled.
For information on configuring the MS5145-38 for
USB Serial Emulation Mode, please refer to the USB
section of the MetroSelect Single-Line Configuration
Guide..
Plugging the scanner into a port on the host system
does not guarantee that scanned information will be
communicated properly to the host system. All
Eclipse’s are shipped already configured with a set of
factory defaults. Please refer to the MetroSelect
Single-Line Configuration Guide or MetroSet2’s help
files for instructions on changing the scanner’s factory
default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 5.
To Next Page
Loading...
