Remove Battery
To remove the battery, complete the following steps:
1. Place the MX7 in Suspend mode.
2. Detach the bottom hook of the handstrap (if installed).
3. Slide the battery retaining clip down to release the main battery.
4. Pull the battery up and out of the battery well with a hinge motion.
Place the discharged battery pack in a powered battery charger.
Hotswap the Main Battery
Place the MX7 in Suspend Mode. Honeywell recommends any work in progress be saved prior to replacing the battery pack.
Simply replace the discharged battery with a fully-charged battery. An MX7, with a fully charged internal battery, will retain data
during a battery hotswap for 5 minutes.
2-3
To Next Page
Loading...
