Chapter 3: Connecting Cables to the MX7
Connecting the USB Client and Power Cable
Note: AC/DC Adapter must be assembledbefore this process begins.
Note: Do not connect AC power to the AC Adapter yet.
1. Holding the cable I/O connector, pinch the catch release buttons in until the catches are open. Connect the cable to the
MX7 I/O port by matching the shape of the I/O connector on the cable with the shape of the I/O connector at the base of
the MX7. Release the catch release buttons.
2. Insert the AC adapter single pin cable .
3. Connect the AC Adapter to a power source (wall outlet).
4. Insert the USB client plug into the target USB Client port.
The MX7 and the USB client are connected.
3-1
To Next Page
Loading...
