Set Speaker Volume
The speaker is located on the front, above the MX7 logo.
Speaker volume can be adjusted to a comfortable level for the listener by using the keypad or by changing parameters in the
Volume & Sounds control panel.
Using the Keypad
Note: Volume & Sounds (in Settings > Control Panel) must be enabled before the following key sequences can adjust the
volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume:
l Tap the Orange key then the Scan key to enter Volume change mode.
l Use the Up Arrow and Down Arrow keys. A beep is emitted at each arrow key press. When the volume reaches
maximum level, two extra beeps are emitted.
l Press any key, except the keys you used to adjust the volume, to exit.
Volume control using a keypad key press has six volume settings that match those supported by the Volume and Sounds
Control panel. Volume does not “roll-over” from minimum to maximum or from maximum to minimum. Continuously holding
down the up or down arrow keys does not cause an automatic repeat of the up (or down) arrow key.
Using the Control Panel
Tap Start > Settings > Control Panel > Volume & Sounds > Volume tab. Change the volume setting and tap OK to save
the change.
You can also select / deselect sounds for key clicks and screen taps and whether each is loud or soft.
As the volume scrollbar is moved between Loud and Soft, the MX7 emits a tone each time the volume increases or decreases.
2-11
To Next Page
Loading...
