Honeywell MX7 - Connecting Vehicle Power; DC to DC Power Supply Installation; Connecting Electrical Cables to Power Sources; Specifications for Electrical Supply

Connecting Vehicle Power
Complete vehicle cradle mounting and power instruction is contained in the MX7Cradle Guide.
TheMX7must have a main battery installed before docking the MX7in a cradle.
DC to DC Power Supply Installation
For use with Honeywell power supplies:
l 9000301PWRSPLY – Power Supply, 18-60VDC with cable
l 9000302PWRSPLY – Power Supply, 60-110VDC with cable
Connecting Electrical Cables to Power Sources
The DC to DC power supply is used to provide vehicle power to the MX7 when placed in a DC powered vehicle dock.
Specifications for Electrical Supply
Input Voltage Always observe input voltage range specified on the DC to DC power supply
Output Voltage 12 VDC ± 10%
Power 60 W
Fuse 5 A (slow blow fuse). Fuses are USER SUPPLIED
Note: Refer to the Wiring Schematic for wiring colors and connections.
Caution:
For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. This
fused circuit requires a five Amp maximum time delay (slow blow) high interrupting rating fuse. If the supply con-
nection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery
positive (+) terminal. Note: For North America, a UL Listed fuse is to be used.
Caution:
For installation by trained service personnel only.
Warning:
Risk of ignition or explosion. Explosive gas mixture may be vented from battery. Work only in well ventilated area.
Avoid creating arcs and sparks at battery terminals.
3-4