Connecting the Serial and Power Cable
Note: AC/DC Adapter must be assembled before this procedure begins.
Note: Do not connect AC power to the AC Adapter yet.
1. Holding the cable I/O connector, squeeze the catch release buttons in until the catches are open. Connect the cable to
the MX7 I/O port by matching the shape of the I/O connector on the cable with the shape of the I/O connector at the
base of the MX7. Release the catch release buttons.
2. Connect the AC adapter single pin cable .
3. Connect the assembled AC/DC Adapter to a power source (wall outlet).
4. Connect the RS232 cable end to the desired serial device. Turn the thumbscrews clockwise until the connection is
finger-tight.
The MX7 and the serial device are connected.
3-2
To Next Page
Loading...
