Set Date and Time Zone 2-9
Grab Time Utility 2-9
Autolaunch Time-Sync 2-9
Synchronize with a Local Time Server 2-9
Set Power Scheme Timers 2-10
Battery Power Scheme 2-10
AC Power Scheme 2-10
Set Speaker Volume 2-11
Using the Keypad 2-11
Using the Control Panel 2-11
Setup Terminal Emulation Parameters 2-12
Using the AppLock Switchpad 2-13
Using the Keypad 2-13
Using the Touch Screen 2-13
Using the Input Panel / Virtual Keyboard 2-14
Connecting Bluetooth Devices 2-15
Taskbar Connection Indicator 2-15
Reboot 2-16
Warm Boot 2-16
Cold Boot 2-16
Attaching the Handstrap 2-17
Attaching the Trigger Handle 2-18
Connecting the Headset Cable 2-19
Adjust Headset / Microphone and Secure Cable 2-20
Cleaning the Touch Screen and Scanner Aperture 2-21
Startup Help 2-22
Continuous Scan Mode 2-22
Chapter 3: Connecting Cables to the MX7 3-1
Connecting the USB Client and Power Cable 3-1
Connecting the Serial and Power Cable 3-2
Connecting an External Power Supply 3-3
Connecting Vehicle Power 3-4
DC to DC Power Supply Installation 3-4
Connecting Electrical Cables to Power Sources 3-4
Wiring Schematic 3-5
Connect Vehicle Electrical Connection 3-5
Vehicle 12V Bare Wire Adapter 3-7
Vehicle Cable Connection Cable (Fuse Not Shown) 3-7
Connecting the Power Cable to the Vehicle 3-8
ii
To Next Page
Loading...
Need help?
General