DOC-02-098:rev B - Page 2 of 2
This document is not intended for installation purposes. We try to
keep our product information up-to-date and accurate. We cannot
cover all specifi c applications or anticipate all requirements. All
specifi cations are subject to change without notice.
© 2015 Honeywell Ltd
ISO9001
FS 520324
ENGINEERING & MANUFACTURING
QUALITY SYSTEMS
For more information please contact your
nearest Notifi er Offi ce or Distributor
www.notifi er.com.au | www.notifi er.co.nz
PRODUCT LINE INFORMATION
DNR-AUS: Intelligent non-relay photoelectric low fl ow smoke detector
housing. Requires photoelectric smoke detector (sold seperately).
DNRW-AUS: Watertight Intelligent non-relay photoelectric low fl ow
smoke detector housing. Requires photoelectric smoke detector
(sold seperately).
FSP-851AUS: FlashScan low-profi le photoelectric smoke detector.
SDX-851AUS: CLIP low-profi le photoelectric smoke detector.
DST1: Metal sampling tube to suit duct widths up to 0.3m
DST3: Metal sampling tube to suit duct widths 0.6m - 1.2m
DST5: Metal sampling tube to suit duct widths 1.2m - 2.4m
DST10: Metal sampling tube to suit duct widths 2.4m - 3.7m
ETX: Metal exhaust tube
SPECIFICATIONS
Mechanical Specifi cations
Dimensions: (Rectangle) 37cm Length; 12.7cm Width; 6.6cm Depth
Dimensions: (Square) 19.7cm Length; 22.9cm Width; 6.6cm Depth
Weight: 0.73kg
Environmental Specifi cations
Operating Temperature: 20˚C to 70˚C
Operating Humidity: 0% to 95% relative humidity (non-condensing).
Ingress Protection: IP66 (DNRW only)
Electrical Specifi cations
Please see photoelectric detector installation manual for electrical
specifi cations.
Airfl ow Specifi cations
Air Duct Velocity: 100 to 4,000 ft/min (0.5 to 20.32 m/s).
To Next Page
Loading...
