DOC-02-159:rev C - Page 5 of 8
DNR: InnovairFlex low-flow non-relay duct-detector housing (order FSP-
851 separately). See DOC-02-098.
DNRW: Same as above with NEMA-4 rating, watertight. See DOC-02-
098.
B501AUS:4” (10.16 cm) universal detector base. See DOC-02-030.
B521IEFT-IV:4” (10.16 cm) universal detector base with in-built short-
circuit isolator. See DOC-02-030.
AAM:Alarm acknowledgement module. Models available in vertical and
horizontal orientation and with (or without) remote indicator; AAM-VL,
AAM-V, AAM-HL. Alarm Acknowledgement Modules. See DOC-02-086.
NFX-BS: CLIP Sounder base, Temporal 3 or Continuous tone. See
DOC-02-144.
NFX-BF:CLIP Beacon base. See DOC-02-144.
NFX-BSF:CLIP Sounder beacon base, Temporal 3 or Continuous tone.
See DOC-02-144.
NFX-WS: CLIP Wall Sounder Temporal 3 or Continuous tone. See
DOC-02-145.
NFX-WF:CLIP Wall Beacon. See DOC-02-145.
NFX-WSF:CLIP Wall Sounder beacon, Temporal 3 or Continuous tone.
See DOC-02-145.
NOTE: NFX addressable AV devices are available in a range of colours.
Colour variants are included as part of the models listed above. For
example red wall sounder is NFX-WS-R. Versions of NFX series
addressable AV are available with in-built short circuit isolator. These are
designated in the model NFXI. for example red wall sounder with isolator
is NFXI-WS-R.
FMM-1:FlashScan monitor module. See DOC-02-040.
FDM-1: FlashScan dual monitor module. See DOC-02-040.
FZM-1:FlashScan conventional zone module. See DOC-02-040.
FMM-101:FlashScan miniature monitor module. See DOC-02-040.
FMM-4-20:FlashScan 4-20 mA protocol monitor module. See DOC-
02-170.
FCM-1:FlashScan control module. See DOC-02-038.
FRM-1:FlashScan relay module. See DOC-02-038.
FDMR-1:FlashScan dual monitor/dual relay module. See DOC-02-033.
NFX-MCP-GLASS: FlashScan manual call point, addressable. See
DOC-02-088.
ISO-X:Isolator module. See DOC-02-042.
WCP-5A:CLIP outdoor manual call point. See DOC-02-088.
XP6-C: FlashScan six-way monitored control module. See DOC-02-
044.
XP6-MA: FlashScan six-zone interface module; connects intelligent
alarm system to two-wire conventional detection zone. See DOC-02-
043.
XP6-R:FlashScan six-relay (Form-C) control module. See DOC-02-045.
XP10-M: FlashScan ten-input monitor module. See DOC-02-046.
IMX-IE: Translator module for use with intrinsically safe devices. See
DOC-02-129
Y-2221:Single channel galvanic isolator for use with IMX-IE. See DOC-
02-129.
SLC-IM:SLC integration module, for VESDAnet detectors or modbus
devices. See DOC-02-174
Enclosures, Chassis and Dress Plates
CABSeriesEnclosures: AFP-3030 mounts in a standard CAB Series
enclosure (available in two sizes, CAB650 and CAB900). The CAB series
encosures are available with a solid and window outer door. A trim ring
option is available for semi-flush mounting.
U Series Enclosures: AFP-3030 mounts in a “U” Series enclosure
(available in three sizes, 18U, 28U and 40U). The “U” Series cabinets are
available with a solid and window outer door. Custom trim ring options
are available for semi-flush mounting.
BMP-1: Blank module for unused module positions.
CHS-3L:Low-profile Chassis. Mounts up to three modules in any CAB
series row.
CHS-4L: Low-profile Chassis. Mounts up to four modules in any U
series row.
CHS-4:Chassis used with the XP6 and XP10 Multi-Modules.
Mounts up to four modules in any CAB series row.
CHS-6: Chassis used with the XP6 and XP10 Multi-Modules.
Mounts up to six modules in any U series row.
CAB650/BB: Enclosure for batteries. The CAB650/BB is used to mount
up to two 40 AH batteries if needed. 250mm high x 450mm wide x
190mm deep. Depth includes door.
18U/BB: Enclosure for batteries and additional equipment. The 18U/BB
is used to mount up to six 40AH batteries (three sets) if needed. 300mm
high x 450mm wide x 190mm deep. Depth includes door.
Other Options
IFS-2008:Agent releasing module for extinguishing agent releasing CIE
in accordance with AS4214.1:2002, AS & ISO14520.1:2009. See DOC-
02-020.
IFS-993:Strobe/sounder interface. See DOC-02-173.
NOTE: For other options including compatibility with retrofit equipment,
refer to the SLC manual, and the AFP-3030 manual.
To Next Page
Loading...
