Honeywell NOTIFIER NFW-50X - 9: Annunciators; 10: Communicator

NFW-50X Manual — P/N LS10129-001NF-E:C 7/25/2018 113
Read Status Operating Instructions
The operator can view all events which have been stored in the history file, only alarms or other events, such as troubles or supervisories,
by pressing the corresponding number key.
4.23.9 Annunciators
Pressing 1 while viewing Read Status Screen #4 will display the following screens:
Pressing 1 or 2 for ANN-BUS while viewing the Annunciator Screen allows the operator to view the settings and devices for each ANN-
BUS. Press 1 for the Primary ANN-BUS and 2 for the Secondary ANN-BUS.
The ANN-BUS Screen #1 indicates if the ANN-BUS has been enabled Yes or disabled No.
Pressing 2 for Modules Installed while viewing ANN-BUS Screen #1 will display screens for ANN-BUS Addresses 1 -8 and the devices
installed at each address. A subscreen will display the options that have been programmed for each device.
Pressing 3 for ANN-BUS Options while viewing the Annunciator Screen allows the operator to view the set-
tings for any ANN-S/PG, ANN-LED, ANN-80, and ANN-100 installed in the system.
Pressing 1 for ANN-S/PG Options while viewing ANN-BUS Screen #2 will display the options selected for the installed N-ANN-S/PG
annunciators.
Pressing 2 for ANN-LED Options while viewing ANN-BUS Screen #2 will display the options selected for the installed N-ANN-LED
annunciators.
Pressing 3 for ANN-80/100 Options while viewing ANN-BUS Screen #2 will display the options selected for the installed N-ANN-80 or
N-ANN-100 annunciators.
4.23.10 Communicator
Pressing 2 while viewing Read Status Screen #4 will display the following screens:
The Communicator Screen #1 indicates if an IPOTS-COM has been installed Yes or No.
Pressing 2 for POTS Settings while viewing Communicator Screen #1 will display settings for the telephone portion of the Communica-
tor.
Pressing 1 or 2 will display whether each phone line is enabled Yes or disabled No, whether the phone type is touchtone or rotary, and
whether the phone line is being supervised Yes or No.
Pressing 3 will display the phone lines’ Gains setting. The value for the Dialing Gains and Reporting Gains is shown as High, Normal, or
Low.
READ STATUS
1=ANNUNCIATORS
2=COMMUNICATOR
Read Status Screen #4
ANN-BUS SELECT
1=PRIMARY
2=SECONDARY
3=ANN-BUS OPTIONS
Annunciator Screen
ANN-BUS
ENABLED NO
2=MODULES INSTALLED
CLASS A NO
ANN-BUS Screen #1
ANN-BUS SELECT
1=PRIMARY
2=SECONDARY
3=ANN-BUS OPTIONS
Annunciator Screen
ANN-BUS
1=ANN-S/PG OPTIONS
2=ANN-LED OPTIONS
3=ANN-80/100 OPTIONS
ANN-BUS Screen #2
READ STATUS
1=ANNUNCIATORS
2=COMMUNICATOR
Read Status Screen #4
COMMUNICATOR
INSTALLED YES
2=POTS SETTINGS
3=IP SETTINGS
COMMUNICATOR
1=PRI COMM PATH
2=SEC COMM PATH
TBL REPORT LIMIT 0
COMMUNICATOR
1=EVENT CODES
TEST TIME INT 24
24HR TEST TIME 0100
Communicator Screen #1
Communicator Screen #2
Communicator Screen #3
COMMUNICATOR
REPORT STYLE POINT
Communicator Screen #4
POTS SETTINGS
1=LINE 1
2=LINE 2
3=GAINS