Need help?Do you have a question about the Honeywell Notifier ID3000 Series and is the answer not in the manual?
General| Enclosure Rating | NEMA 1 |
|---|---|
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Relative Humidity | 10% to 93% non-condensing |
| Power Supply | 24 VDC |
| Standby Current | Consult product documentation for specific standby current based on configuration. |
| Alarm Current | 3.0 A |
| Communication | RS-485 |
| Display | LCD |
| Type | Addressable Fire Alarm Control Panel |
| Networking | Yes, supports peer-to-peer networking |
Specifies that installation must be carried out only by suitably-qualified electrical engineers.
Highlights high voltage risks and static-sensitive device precautions to consider during installation.
Instructs to check all supplied equipment for damage before installation, returning faulty items.
Provides rules for installing cables, including IEE regulations, screening, and glands.
Guides on cable entry points and termination for internal/external PSU configurations.
Emphasizes using quality cable and correct installation techniques for RFI/EMC compliance.
Details EN54-2 requirements for loop devices, sensors, MCPs, and isolators.
Lists checks before initial power connection, including boards, wiring, and outputs.
Details checks for loop continuity, resistance, and polarity before connecting.
Provides battery ratings for back box options and connection procedures.
Step-by-step guide for connecting batteries to the Kit PSU3A.
Recommends daily, weekly, quarterly, and annual checks for system maintenance.
Lists common ID²net network fault messages and their possible causes and remedies.
To Next Page