THIS MANUAL COVERS THE FOLLOWING MODELS:
TH2110D: For 1-Heat / 1-Cool systems
TH2210D: For 2-Heat / 1-Cool heat pump systems (Remove the thermostat from its wallplate to find the model number.)
CAUTION: EQUIPMENT DAMAGE HAZARD.
To prevent possible compressor damage, do not use Cooling mode when the outdoor temperature is below 50 °F (10 °C).
ABOUT YOUR NEW THERMOSTAT
Your new Resideo thermostat has been designed to give you many years of reliable service and easy-to-use, push-button
climate control.
Features
Backlit display is easy to read
Displays ambient (measured) temperature at all times
One-touch access to setpoint temperature
Preprogrammed schedule can greatly reduce your heating/cooling expenses
Separate programmable weekday/weekend schedules (5+2 day programming)
Temporary and permanent override of schedule
Adaptive Intelligent Recovery™ ensures right temperature at the right time
Built-in compressor protection
THIS THERMOSTAT IS READY TO GO
Simply perform the three steps below and the thermostat is in operation:
1. Set the clock. See page 2.
2. Select whether to heat or cool. See page 2.
3. Select whether to run the fan continuously or only when needed. See page 3.
If you do not wish to use the pre-programmed schedule settings, you can:
Modify the schedule. See page 3.
Temporarily override the schedule. See page 4.
Permanently override the schedule. See page 4.
QUICK REFERENCE TO CONTROLS
To Next Page
Loading...
