(The changes are also saved if you do not press any button for 60 seconds.)
NOTE: The clock has lost its settings when the time display flashes. If the thermostat is following the schedule, it will use the
temperature settings programmed for the Wake period of the weekdays until you readjust the clock.
SYSTEM SWITCH
Use the System switch to place the system in one of the following modes:
Cool: System is in Cooling mode.
Off: System is off.
Heat: System is in Heating mode.
Em Heat: System is in Emergency Heat mode. Only auxiliary heating can be activated. The compressor is disabled. (This
mode is available on the TH2210D model only.)
FAN SWITCH
Use the Fan switch to select the fan operation.
Auto: The fan runs only when heating or cooling is activated (commonly used setting).
On: The fan runs all the time.
USING THE SCHEDULE
To Next Page
Loading...
