Press the Run button to follow the programmed schedule. For maximum energy savings while maintaining comfort, you can
program the schedule such that the temperature is at an economical level when you sleep or leave for work and at a
comfortable level when you are awake and at home. You can program up to four periods per day:
Wake Starts when you wake up
Leave
Starts when you leave for
work
Return
Starts when you return
home
Sleep Starts when you go to sleep
To program a period, you need to set its start time and its two temperature settings (one when the thermostat is in cooling mode
and another one when it is in heating mode). The same settings are used every day from Monday to Friday and another set of
settings are used for Saturday and Sunday. For example, you could program all four periods for the weekdays but only two
periods (Wake and Sleep) for the weekends.
PREPROGRAMMED SCHEDULE SETTINGS
The thermostat is preprogrammed with the following settings.
Period
Weekdays Weekends
Start time Heat Cool Start time Heat Cool
Wake 6:00 am 70 °F (21 °C) 75 °F (24 °C) 6:00 am 70 °F (21 °C) 75 °F (24 °C)
Leave 8:00 am 62 °F (16.5 °C) 83 °F (28.5 °C) – – – – – –
Return 6:00 pm 70 °F (21 °C) 75 °F (24 °C) – – – – – –
Sleep 10:00 pm 62 °F (16.5 °C) 78 °F (25.5 °C) 10:00 pm 60 °F (15.5 °C) 78 °F (25.5 °C)
These settings can reduce your energy bills. See the next page if you wish to modify them.
MODIFYING THE SCHEDULE
1. Press the Set button 3 times until Set Schedule appears. The start time of the first period (Wake) of the week days (Mon-
Fri) will flash.
2. Press the or button to set the time.
3. Press the Set button. The temperature setting for that period will flash.
4. To program the temperature settings for the cooling mode, place the System switch in Cool. To program the temperature
settings for the heating mode, place the switch in Heat.
5. Press the or button to set the temperature.
6. Press the Set button. The start time of the next period will flash.
7. Repeat steps 2 through 6 for each of the remaining periods.
8. Once all adjustments are made, press the Run but-ton to save them and exit. (The changes are also saved if you do not
press any button for 60 seconds.)
TEMPORARY OVERRIDE OF SCHEDULE
To Next Page
Loading...
Need help?
General
