Honeywell Pro-Watch 6000 - Jumper Settings

Installing the PW-6000 Two-Reader Module
Setup
PW-6000 Two-Reader Module Installation Guide, Document 800-01951, Revision C 3
Setup
Setting Jumpers
Table 1: Jumper Settings
Jumper Setting Default Selected
J1 OFF * Port 1 RS-485 EOL
terminator is not active
ON Port 1 RS-485 EOL
terminator is active
J2 OFF * Reader 0 Power Terminal
provides 5 VDC
ON Reader 0 Power Terminal
provides 12 VDC
J3 OFF * Reader 1 Power Terminal
provides 5 VDC
ON Reader 1 Power Terminal
provides 12 VDC