90 PX4i and PX6i High Performance Printer User Guide
Ribbon Fitted This is not an error condition. This message briefly appears after a
new roll of transfer ribbon is installed.
Blinking
Printhead Up The printhead is lifted. Lower the printhead. Blinking 1027
Open & Shut
Cutter
Cutter error 1. Open and shut the cutter. Blinking 1058
Open & Shut
Cutter
Cutter error 2. Open and shut the cutter. Blinking 1022
Open & Shut
Cutter
Cutter error 3. Open and shut the cutter. Blinking 1059
Paper Fault LSS too high. This error can occur when you run a test feed
without any media installed, or if you have incorrect media
settings. Load the printer with media and select the appropriate
media type. For help, see "Loading Media" on page 5.
Blinking 1701
Paper Fault LSS too low. This error can occur when you run a test feed without
any media installed, or if you have incorrect media settings. Load
the printer with media and select the appropriate media type. For
help, see "Loading Media" on page 5.
Blinking
Paper Fault The printer did not perform a test feed before it printed out test
labels. Performing a test feed calibrates the sensor. To perform a
testfeed, press the button.
Blinking
Press Feed
Press the button to resume.
Blinking
Paused This is not an error condition. This message appears when the
print job is paused.
Blinking
Setup mode entered. Off
IP link error. No network connection. Blinking
IP configuration error. The printer is trying to acquire an IP
address from the network. Wait for the printer to complete the
task before taking any action.
Blinking
No Printhead Printhead not found Off
Rebooted Off
Initializing Off
Printer crash. In most instances, when the printer crashes, the
screen is reset which causes the Ready-to-Work indicator to turn
off.
Off
Printer turned off Off
Maintenance Off
Psu Over Temp Power supply over temperature Off
Printhead Hot The printhead is overheated and needs to
cool down. Wait for printing to resume automatically.
Off
Message Description Ready-to-Work
Indicator
Status
Error
Number
To Next Page
Loading...
