Honeywell PX6i - Page 147

PX4i and PX6i High Performance Printer User Guide 135
Fingerprint Media Menu
Fingerprint Print Defs Menu
TRANSFER:
LOW DIAMETER
TRANSFER:
RIBBON SENSOR
TRANSFER:
LABEL OFFSET
TRANSFER:
RIBBON FACTOR
TRANSFER:
RIBBON CONSTANT
MEDIA TYPE:
TICKET (w MARK)
MEDIA TYPE:
LABEL (w GAPS)
MEDIA SIZE:
LENGTH
MEDIA SIZE:
WIDTH
SETUP:
MEDIA
MEDIA:
MEDIA SIZE
MEDIA SIZE:
XSTART
MEDIA:
MEDIA TYPE
MEDIA TYPE:
VAR LENGTH STRIP
MEDIA TYPE:
FIX LENGTH STRIP
MEDIA:
PAPER TYPE
PAPER TYPE:
TRANSFER
MEDIA:
CONTRAST
PAPER TYPE:
DIRECT THERMAL
DIRECT THERMAL:
LABEL FACTOR
DIRECT THERMAL:
LABEL CONSTANT
TESTFEED MODE:
SLOW
MEDIA:
LEN (SLOW MODE)
MEDIA:
TESTFEED
MEDIA:
TESTFEED MODE
TESTFEED MODE:
FAST
LENGTH:
1200
WIDTH:
832
XSTART:
24
LOW DIAMETER:
0
RIBBON SENSOR:
14
LABEL OFFSET:
0
RIBBON FACTOR:
25
RIBBON CONSTANT:
90
LABEL FACTOR:
40
LABEL CONSTANT:
85
CONTRAST:
+0%
TESTFEED:
26 28 0 10
MEDIA:
PAPER
PAPER:
LOW DIAMETER
PAPER:
PAPER SENSOR
LOW DIAMETER:
0
PAPER SENSOR:
10
Only displayed if a paper sensor is installed.
+0%/+2%/+4%/+6%
+8%/+10%/-10%/-8%
-6%/-4%/-2%/-0%
LEN (SLOW MODE):
0
Press E to perform a
testfeed. Values are
read-only.
CMD LANGUAGE:
DSim
CMD LANGUAGE:
ZSim
CMD LANGUAGE:
IPL
CLIP DEFAULT:
OFF
TESTPRINT:
NETWORK INFO
TESTPRINT:
RFID TEST LABEL
TESTPRINT:
HARDWARE INFO
TESTPRINT:
SETUP INFO
TESTPRINT:
BAR CODES #2
TESTPRINT:
BAR CODES #1
TESTPRINT:
CHESS
PRINT DEFS:
TESTPRINT
LTS:
LTS ADJUST
LTS:
LTS TEST
LTS:
LTS VALUE
LTS VALUE:
10
TESTPRINT:
DIAMONDS
PRINT DEFS:
PRINT SPEED
PRINT DEFS:
LSS TEST
PRINT SPEED:
100
LSS TEST:
LSS MANUAL
LSS [G: 1]D: 13

REMOVE LABEL
ENTER TO STOP
REMOVE LABEL AND
PRESS ENTER
SETUP:
PRINT DEFS
PRINT DEFS:
HEAD RESIST
HEAD RESIST:
nnn
LSS TEST:
LSS AUTO
LSS AUTO:

Toggle between
gain (G) and drive (D)
Decrease or increase
value in brackets
PRINT DEFS:
LTS
SENSITIVITY 10
OUT OF 9-10
PRINT DEFS:
CMD LANGUAGE
PRINT DEFS:
CLIP DEFAULT
CLIP DEFAULT:
ON
CMD LANGUAGE:
Direct Protocol
CMD LANGUAGE:
Fingerprint
Only displayed if a paper sensor is installed.