56 PX4i and PX6i High Performance Printer User Guide
To enter non-alphanumeric octets, use “%nn,” where nn is two hexadecimal digits
representing the value of the character.
Note: The default password for logging in as an admin is “pass.” If you have changed the
password, you will need to use your password instead of “pass.”
2. Send the following commands to configure the WEP keys. The following
example sets WEP key 1 to 01234 and enables WEP key 1.
setup "wlan","WEP1","0x3031323334"
setup "wlan",".WEP_KEY","1"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
To configure the printer to use WPA-PSK or WPA2-PSK mode
1. Send the following commands to login as an admin and set the SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 alphanumeric characters.
To enter non-alphanumeric octets, use “%nn,” where nn is two hexadecimal digits
representing the value of the character.
Note: The default password for logging in as an admin is “pass.” If you have changed the
password, you will need to use your password instead of “pass.”
2. Send one of the following WPA/WPA2 ON commands to turn on WPA or WPA2
authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared
key:
setup "wlan","WPA","OFF"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK","xxxxxxxxxx"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
where xxxxxxxxxx is a value between 8 and 64 characters.
To configure the printer to use WPA or WPA2 Enterprise mode
1. Send the following commands to login as an admin and set the SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 alphanumeric characters.
To enter non-alphanumeric octets, use “%nn,” where nn is two hexadecimal digits
representing the value of the character.
Note: The default password for logging in as an admin is “pass.” If you have changed the
password, you will need to use your password instead of “pass.”
To Next Page
Loading...
