2 Applicator Interface Kit Installation Guide
4. Remove the eight #T10 Torx screws that hold the left-hand cover.
5. Put the cover aside on a soft cloth or similar to avoid scratches.
6. Remove the one or two cover plates depending on how many interface
boards you are going to install. Each plate is held by two #T10 Torx screws.
Note: Applicator interface card must be installed in the innermost position.
7. Save the cover plate(s) for possible later use. Keep the screws.
Warning: The electronics compartment contains high voltage
components and wires. Do not open the electronics
compartment before the printer is safely disconnect from
any AC supply.
Inner cover plate
Outer cover plate
To Next Page
Loading...
