BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
EN1B-0198GE51 R1004B 33
whether to take over the new settings.
If this is denied, the old settings will be
restored. Otherwise, the new settings
are stored to the Flash memory and the
system needs to be restarted to activate
the new settings.
delete deletes basic network settings. Please
note that after this operation the BNA
device will not operate on the LAN
anymore. After commanding delete,
new basic network parameters must be
entered via modify.
altmac definition of an alternative MAC-
address. This command is available
only for the sake of completeness. Each
BNA already comes with a unique
Ethernet address (MAC address). So
there will be no need to define a new
MAC address. It is recommended to
not use this command unless advised to
do so by the Honeywell Technical
Assistance Center.
exit exits the sub-shell and returns to the
main shell.
6.5.3 dc - Download configuration
The download configuration command dc is used
to have a predefined way of retrieving new
application firmware versions when an update of
the same becomes necessary.
To Next Page
Loading...
Need help?
General
