Owner’s Guide
6
Push the excess wires back inside the
electrical box.
Secure the thermostat to the electrical
box using the provided screws. Insert the
screws through either the right or left pair
of mounting holes on the thermostat.
NOTE: If there is a protective film or
sticker on the thermostat’s screen, peel it
off.
Apply power to the heating system. Verify the installation by checking
that the heater can be turned on by raising the setpoint using the Up
button and off by lowering the setpoint using the Down button.
Keep the thermostat's air vents clean and free from obstructions.
Mounting the thermostat
400-104-010-D_69-1855EF (RLV430 Honeywell TH104) ENG.fm Page 6 Monday, August 31, 2009 1:16 PM
To Next Page
Loading...
