Page 17 of 18 APHITEMPCON001-11-04
Default Setting:
S e t t i n g P a r a m e t e rs D e fa u lt V a lu e
Z - B A N D 1 . 5 °C
D IF F 0 . 5 °C
P - B A N D 2 . 0 °C
O F F S E T 0 °C
M O D E
C / A L
( C O O L + A L A R M )
R E V E R S E O F F
D IS P L A Y O F F
M A N U A L O F F
S P 2 1 °C
F 1 (I) 1 5 S E C
A L A R M (F 2 ) 1 0 °C
IMPORTANT: Before setting, please check the following points.
1. Inspect the controller visually & check the push button before connecting the main power.
2. There should not be any abnormal phenomena or obvious shipping damage.
3. Check the Selector Switch & make sure that the switch is set at the right position.
To Next Page
Loading...
